Unpack all the parts and lay them out on a flat surface. Check the contents of the shipment.The assembly principle applies to the entire Filar collection.

Let’s start by reviewing the parts of the shelf. The Ferro Duo version should include a 180 cm shelf. For the standard Ferro version, you should receive a 100 cm shelf. Familiarize yourself with the components included in the package.

The shelf we’ll be mounting in this instruction is the Ferro Duo version. Follow the same steps and order when assembling the 100 cm Ferro version.

Use the arched rod element as a template. Choose the appropriate spot and place the steel element against the wall to mark the drilling points. To ensure proper alignment, use a spirit level. Mark the exact points where you will drill.

According to the illustration, the spacing between the holes in the wall should be exactly 80 cm.

The hole depth and diameter should match the wall plug included in the set. Please note that the provided plugs are intended for solid concrete or brick walls. If your wall is made of a different material, you should choose appropriate plugs on your own.

After drilling the holes, insert the wall plugs into the openings, then screw in the double-threaded studs with an M8 end. The studs should protrude from the wall no more than 20 mm.

Now it’s time to prepare the shelf. Pay attention to the placement of the holes in the shelf — they are not centered. The distance from the hole to the wall should be greater than the distance to the front edge of the shelf.

Insert the round steel washers into the recesses in the shelf. Then, screw the adjuster onto the threaded end of the rod and insert the rod with the adjuster into the holes. The threaded ends will appear on the opposite side of the shelf.

Place the round steel washer onto the threaded rods protruding from the shelf recesses, then screw on the decorative nut. You can tighten the nut by hand — the knurled surface makes it easy to grip.

To mount the shelf on the wall, slide the arched rods onto the threaded bolts protruding from the wall. Follow the steps as shown in the illustration. Do this carefully to ensure the arches do not slip off the threads.

Now take the previously prepared shelf with the rods and hang it on the threaded bolts protruding from the wall. While doing so, you can start screwing on the decorative nuts directly during mounting.

Make sure the shelf is securely mounted on the brackets and that each decorative nut is tightened. You can now start using your shelf. Please note that the maximum load is 10 kg and may vary depending on the type of wall material.

Thank you for your attention. Your shelf is ready to use.